大家好，又见面了，我是你们的朋友全栈君。
TB6612FNG电机驱动模块
TB6612的的用法：
TB6612是双驱动，也就是可以驱动两个电机 下面分别是控制两个电机的IO口 STBY口接单片机的IO口清零电机全部停止，置1通过AIN1 AIN2，BIN1，BIN2 来控制正反转 VM 接15V以内电源 VCC 接2.7v – 5V电源 GND 接地
驱动1路 PWMA 接单片机的PWM口 真值表： AIN1 0 0 1 AIN2 0 1 0 停止 正传 反转
A01 AO2 接电机1的两个脚
驱动2路 PWMB 接单片机的PWM口 真值表： BIN1 0 0 1 BIN2 0 1 0 停止 正传 反转 B01 BO2 接电机2的两个脚
注意： 若是pwm控制，则需要pwm频率100khz ，亲测80khz也好用，同时STBY引脚需要接高电平
Description: The TB6612FNG motor driver can control up to two DC motors at a constant current of 1.2A (3.2A peak). Two input signals (IN1 and IN2) can be used to control the motor in one of four function modes – CW, CCW, short-brake, and stop. The two motor outputs (A and B) can be separately controlled, the speed of each motor is controlled via a PWM input signal with a frequency up to 100kHz. The STBY pin should be pulled high to take the motor out of standby mode.CJMCU.
Logic supply voltage (VCC) can be in the range of 2.7-5.5VDC, while the motor supply (VM) is limited to a maximum voltage of 15VDC. The output current is rated up to 1.2A per channel (or up to 3.2A for a short, single pulse).
Board comes with all components installed as shown. Decoupling capacitors are included on both supply lines. All pins of the TB6612FNG are broken out to two 0.1″ pitch headers; the pins are arranged such that input pins are on one side and output pins are on the other.
Features:
Power supply voltage: VM=15V max, VCC=2.7-5.5V Output current: Iout=1.2A(average) / 3.2A (peak) Standby control to save power CW/CCW/short brake/stop motor control modes Built-in thermal shutdown circuit and low voltage detecting circuit All pins of the TB6612FNG broken out to 0.1″ spaced pins Filtering capacitors on both supply lines
发布者：全栈程序员栈长，转载请注明出处：https://javaforall.cn/126169.html原文链接：https://javaforall.cn
